1Pc 6LED Auto Solar Charger Car Burglar Alarm Lamp Sensor Security Warning Light

Features:
100% Brand New!
Rechargeable Solar power Sources
Lighting senser control
6 pcs high quality LED (6 blue)
Small power consumption
Size:6cm*3cm*1.3cm

6 lights need to know before buying
This product is mainly used for psychological intimidation
Read the instructions carefully, please use them correctly
This product is not covered by the warranty if the product is modified by the customer (including wiring) for use outside the vehicle.

Features:
6 intimidating LEDs, you can see the intimidation led from outside the car at night, you can play an effective threat.
Strong light is emitted from 6 LEDs.
The built-in vibration sensor is that as long as the vibration is sensed, the six LED lights will be turned on and emit intense light.
Built-in automatic light source, automatic stop during daylight, automatic control after dark.
Automatic charging mode, automatic charging during the day, will automatically control the lighting after dark.
In OFF mode, it will also be automatically charged during the day.
After the product is taken out, just use double-sided tape to paste it.
(vehicle anti-theft alarm device)

Wipe the area that will be pasted with a neutral detergent.
After bonding the two sides of the glue, reach the strongest viscosity in about 24 hours.
Do not stick double-sided tape on dirty or rough surfaces

Instructions:
Place the product in a place visible outside the vehicle (such as the right side of the front windshield)
Place the product in direct sunlight
Select the place, tear off the low-sided paper inside the double-sided tape, and paste it.

¡¾Turn on¡¿
ON/OFF switch on the side of the product
When the product is in use, the ON is on. When not in use, please put the switch in the OFF position.
Vibration center
In the state where no vibration is sensed, the 6 LED is usually lit alternately, that is, it is in the detection state, and it is activated after one vibration induction.
Alarm mode

[Intimidation status]
Vibration plus 2 vibrations within 5 seconds Vibration 10 seconds flash mode
After the first vibration for 10 seconds, add 3 vibrations and select it, that is, switch to the stop state, it will not light within 60 seconds.

Precautions:
Please read the instructions carefully: use it correctly.
Please do not place it in a place that is unsuitable for driving and obstructing safety devices (eg airbags, seat belts).
This product LED light can not be replaced.
Depending on the climate and the environment, there will be charging dissatisfaction during the day.
When there is no sunlight and cannot be fully charged